Yes, we have been printing on stock Bambu's with .4 nozzles. We do dry the filament before printing.

@kenche hello dude can you share?

@mcobb purchase a little larger size, take it to a glass cutter and have them trim it to size.

@zadstyx You should post this under other printer support instead of the Pulse 3D forum

@mburman Snow has not been online for two years. Have you given MatterHackers a call yet?

@chetb You should have "Other" in your list and "Other Other" which you can use to create a custom profile. Or you can create a brand new profile with the links below.

https://www.matterhackers.com/articles/how-to-integrate-a-custom-printer-profile-into-mattercontrol
http://wiki.mattercontrol.com/Custom_Printer_Profiles

@badincite depends what they are printed with. I printed all of my hotend mounts using carbon fiber nylon, which is strong enough to take any collision. If the metal ones are inexpensive, I would go with that.

Looks like my bad. Accessed the board and I was plugged into E1 instead of E0. Extruder now feeding but not laying down. Noz =215 bed =75 speed= 50 don't know what to do with z setting .2mm noz gap. stock pla trying to print bengy. nothing sticking. thoughts?? Thanks, Joe

@mpirringer thanks I will try the glue stick or hair spray

@cope413 that did not work. Thanks though

@belezeebub

You describe the exact situation I find myself in today. Recognizing your post is nearly 2 years old, I wonder what printer you chose and whether you were satisfied by its performance. Please let us know. I'm ready to pull the trigger on a good printer but would appreciate an objective review.

Also when do you think you might have the E3D Hemera HotSide Kit back in stock?