I also had a question on a separate topic about using octoprint with the pulse? If you know anything that would be great. And you mentioned that you have the duet electronics system, does this upgrade create better prints and if so how much was the upgrade all in and what components did you change?
Jacob5421
@Jacob5421
Posts made by Jacob5421
-
RE: Pulse E432s Firmware
-
RE: Pulse E432s Firmware
@tinken I haven’t been able to figure out how to print from sd card. Would I also need to change the start code in cura to the same thing.
-
RE: Pulse E432s Firmware
@tinken
The top is the start gcode from mattercontrol, the bottom is of a recent print with updated settings and no mesh bed leveling occured before the start. -
RE: Pulse E432s Firmware
So, what do I need to do to fix this. I have uninstalled mattercontrol 2 twice and I haven’t changed the start code.
-
RE: Pulse E432s Firmware
To get around the issue I have turned off the bed leveling procedure before each print, but it does mean that the first layer seems to go down correctly
-
RE: Pulse E432s Firmware
I am currently not near my computer or printer I will do that when I get a chance
-
RE: Pulse E432s Firmware
@tinken I slice in cura then I open the file in mattercontrol and print via usb
-
RE: Pulse E432s Firmware
I don’t know how to access the height map, it does the leveling process then goes to start the purge line and it extrudes in mid air.
-
RE: Pulse E432s Firmware
When is do this it does the leveling process, then starts printing 4-5mm above the build plate. Any guess as to why it would be doing this?