Pulse XE enclosure modification

[mavin]

So I added 2 rear exhaust fans to the cabinet and an exhaust fan to the controller cover

Bought everything on Amazon
3 pak of 60mm fans
rubber anti vibration mounts
Fan 3/4 pin to Molex adapters for the fans
12in 4pin Molex extension cables
a ATX power supply (with qty 3, 4pin Molex leads
and just because, added a DC break out board connected to the ATX 20 pin connector. (will build a case/mount for that)

Will be adding a fan speed controller at later date

Wiring layout attached

[tinken]

@mavin Exhaust fans are not a good idea for the enclosure unless you are only printing PLA. All other materials like the warmer temperatures inside the cabinet. I sealed my two holes off. If you are printing Nylon, the off gassing is hydrogen cyanide, and Nylon requires heat in the chamber.