Pulse XE enclosure modification



  • So I added 2 rear exhaust fans to the cabinet and an exhaust fan to the controller cover

    Bought everything on Amazon
    3 pak of 60mm fans
    rubber anti vibration mounts
    Fan 3/4 pin to Molex adapters for the fans
    12in 4pin Molex extension cables
    a ATX power supply (with qty 3, 4pin Molex leads
    and just because, added a DC break out board connected to the ATX 20 pin connector. (will build a case/mount for that)

    Will be adding a fan speed controller at later date

    Wiring layout attached

    0_1633976795321_enclosure wiring.PNG



  • @mavin Exhaust fans are not a good idea for the enclosure unless you are only printing PLA. All other materials like the warmer temperatures inside the cabinet. I sealed my two holes off. If you are printing Nylon, the off gassing is hydrogen cyanide, and Nylon requires heat in the chamber.


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.