E3D Hotend Assembly Help
clabbott76 last edited by
Anyone purchase a chimera hot end recently? I was following the assembly instructions and there is a picture of them using a wrench to tighten the heat break to the heater block. Closer look showed two flat edges near the threads. My heat breaks have no flat edges. I would need to grip it with pliers which will cut up the part that slides into the cooler block. Any suggestions?
dgaylord MatterHackers last edited by
Looks like the newest version of the Chimera does NOT have those flats machined on the heat break. Should be ok though - thread in the heat break loosely to the correct location, then tighten the nozzle against the heat break. You should be able to hold the heartbreak with your fingers to prevent rotation, if you need to use a tool for the Heat Break use a soft pair of pliers as to not scar the Stainless Steel. We will reach out to E3D and see if they can update instructions.