Can’t make flexible parts stick to bed



  • CAn anyone help me to stick the flexible (TPU 85A) to the bed? It stays there for a while and then start to up from the bed.

    See the photos please!

    1_1567671406258_02B63853-20CB-4B29-823D-A68AFA57EF91.jpeg 0_1567671406258_5C98A8EE-16BB-49FD-BDF2-CC4FD058E2D6.jpeg

    I even use the tesa 2 ways stick!


  • MatterHackers

    Bed adhesion issues can be tricky for sure!

    I am not entirely sure what bed surface that is but it almost looks like some sort of tape. Correct me if I am wrong.
    I would try using some good ol' gluestick on the bed while the bed itself is at room temperature then trying to run a print. It also looks like you are using a brim, which is a step in the right direction. You will also want to make sure you have your cooling fans disabled when printing with this flexible material and slowing your speeds down to ~20mm/s.
    We also have an article we have written on printing with Flexibles which you can find below:

    https://www.matterhackers.com/news/how-to-succeed-when-printing-with-flexible-filament


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.