Is this a Temperature or Extrusion problem?
jmoody last edited by jmoody
This is printed on a Rostock Max v2 with a bed temp of 100 deg and a hotend temp of 235. I am going to try reprinting at 240 to see if I get a better result because I get great adhesion to my PEI bed, but the printed layers are easier to pull apart the higher I get. About half-way up it looks like it might have been under extruding slightly, but that may just be the temp change too. Any ideas?
jmoody last edited by
Does this forum not allow pictures? Won't add them...
ryan.lutz last edited by
@jmoody Sorry, there's a bug with the image uploads right now. 1 MB is the limit for image files, so scale down if necessary for now.