Does this forum not allow pictures? Won't add them...
Posts made by jmoody
Is this a Temperature or Extrusion problem?
This is printed on a Rostock Max v2 with a bed temp of 100 deg and a hotend temp of 235. I am going to try reprinting at 240 to see if I get a better result because I get great adhesion to my PEI bed, but the printed layers are easier to pull apart the higher I get. About half-way up it looks like it might have been under extruding slightly, but that may just be the temp change too. Any ideas?
Is there a guide to upgrading the Rostock Max v2?
It has been suggested that the Rostock Max v2 can be upgraded to work with all the filaments that MatterHackers sells.
I want to purchase the E3D All-metal v6 HotEnd Kit, the Bondtech QR Extruder, with a stainless steel tip... from my understanding, I will have to setup the printer to no longer use the Bowden tube system. Is there a guide out there that shows what parts are necessary in order to setup the printer corectly?