Soft PLA and PEI Bed - What's the Best Way to Remove Prints?
-
The first test print came out well, though removing it from the PEI bed was a huge pita. One of the corners of the print tore because of adhesion The temp settings I use are:
Bed: 60C
Extruder: 210CThis looks like a versatile filament, or it will be once I get over this hurdle.
Any help would be greatly appreciated.
-
Hey @RussF
So my first question is, how close to the bed are you? It sounds more like you are adhering the filament to the plate too well. Mind dropping us a few pictures of the model on the plate if you have any.
TBH, too much adhesion is not all that common of a problem for PEI so I am intrigued by this one.