Can not change bed leveling probe points
-
I have mattercontrol working for the most part but cannot find where to change the test points for bed leveling. It will go through three points but the first and second are at the same point. I have changed the ones in my eprom and that doesn't make a difference.
-
Hey @jonathan9573
At the moment I do not know if a way to change the actual locations for the probe points but you can increase the definition of the probing by selecting the "Leveling solution" and increasing the mesh as shown below in the "Printer" then "Features" tab
-
You actually can set any custom positions you want. Below is a screen shot of them on the Printer tab.
-
Thank you so much. I saw that drop down box but didn’t noticed it had a scroll bar. Totally missed that. Hiding it from everyone apparently. Lol
-
Noting that one as well!
Edit: Ah I see, the Custom option is hidden on my screen below the "100 point disk" which I had to scroll for.