---

General Discussion

• C

  Pulse XE wire off
  • ChadG

  1
  1
  Posts
  190
  Views

  No one has replied

• O

  Pulse 3d printer concern:
  • ozzy5

  2
  2
  Posts
  768
  Views

  

  @ozzy5 Pulse is a very reliable printer, parts are available at Matterhackers.

• M

  This topic is deleted!
  • monetize

  1
  1
  Posts
  4
  Views

  No one has replied

• 

  This topic is deleted!
  • apporio

  1
  1
  Posts
  5
  Views

  No one has replied

• A

  This topic is deleted!
  • aayanali

  1
  1
  Posts
  22
  Views

  No one has replied

• 

  This topic is deleted!
  • Simone006

  1
  1
  Posts
  46
  Views

  No one has replied

• M

  This topic is deleted!
  • mike147

  1
  1
  Posts
  14
  Views

  No one has replied

• 

  This topic is deleted!
  • cmsattamatka05

  1
  1
  Posts
  12
  Views

  No one has replied

• 

  This topic is deleted!
  • BuilderHardware

  1
  1
  Posts
  7
  Views

  No one has replied

• 

  This topic is deleted!
  • hanrymark450

  1
  1
  Posts
  3
  Views

  No one has replied

• 

  How MatterControl evaluate the bed boundaries with BLTouch Offset?
  • seaquest42

  2
  2
  Posts
  1459
  Views

  

  If your bed size is 220 x 220, then it is not rectangular. P1 should probe the bed center (G28) prior to bed mesh (G29). Make sure Has Z probe is on and z servo is also on.

• 

  This topic is deleted!
  • David90Johnson

  1
  1
  Posts
  14
  Views

  No one has replied

• G

  This topic is deleted!
  • GetSecurityaustin00

  1
  1
  Posts
  4
  Views

  No one has replied

• S

  This topic is deleted!
  • syamala

  1
  1
  Posts
  13
  Views

  No one has replied

• J

  This topic is deleted!
  • jooyasho

  1
  1
  Posts
  9
  Views

  No one has replied

• 

  This topic is deleted!
  • alenmartin

  1
  1
  Posts
  7
  Views

  No one has replied

• 

  This topic is deleted!
  • alenmartin

  1
  1
  Posts
  1
  Views

  No one has replied

• D

  D Series vs E Series Pulse printers?
  • Drummermls

  2
  2
  Posts
  1675
  Views

  

  I own both. D series is 12v with an external power supply and an 8 bit cnc board. E series is 24v with a Meanwell power supply attached to the frame. E series comes with either 8bit or 32 depending on the configuration. Either printer may come with a magnetic base.

  I do feel that the website technician needs to pay a little more attention to defining the details on the refurb pulse printer listing.

• S

  This topic is deleted!
  • svmgroup0909

  1
  1
  Posts
  9
  Views

  No one has replied

• C

  This topic is deleted!
  • Contarino

  1
  1
  Posts
  19
  Views

  No one has replied