NeoPixel LEDs controled by M109
-
For our printer we need to use M109 to control case light.
But Matter Control convert automaticly M109 to M104.
how can i remove the automatic convert ?
-
@midgardian Are you sure? M109 is wait for hotend temp and M104 is set hotend temp. I have seen a lot of funkyness in MC but that seems to be working otherwise there would be complaints of cold extrusions all over the place
-
Yes I am Sure ,
In Marlin 2.0 you need to Use M109 and Not M104 to activate the case light
if you use M104 the neopixel leds don't work.
if you use M109 the leds goes from green to red until the température is reach and go to white at printing start.
So we need to use M109 and not M104
-
It's for printer event LEDs not for case light sorry
-
Check your Start Gcode then