Reassembled e3d v6 hotend. Not reaching temp
OkiMitch last edited by
Had a problem where filament always jammed and clogged from nozzel to heat block.
I took the e3d v6 apart and pulled out filament.
Now after reassembled the hotend won’t reach target temp. I get the error saying it takes too long.
Trying for 215 for Esun pla +
mpirringer last edited by
@okimitch Make sure the heater cartridge and thermistor are seated properly MH has a web page with pics and I think a video on how to assemble it properly. Also make sure there is no filament left inside like black stuff on the back of the nozzle or heatbreak if it is you will form a Puck sooner or later and have a jam