for this nice software.
The prints have an excellent quality.
especially the support structure is way better than in S3D.
I did a couple of prints with:
-support percent "Little" 10%
other settings are default.
It turns out very nice, no problem with loose support like in S3D.
....very nice work, I'm so happy that I found this software.
Awesome. Always good to hear. Let us know if you have any issues or questions.
For the support material I have a question:
How can I set the maximum overhang angle?
Is it adjustable?
When I export the profile of my printer there is an varaiable that can not be found in Matter control.
ryan.lutz last edited by
Thanks for your great post! Glad to hear you're enjoying the software.
Overhang is calculated based on the Support Percent setting: http://wiki.mattercontrol.com/SETTINGS/General/Support_Material/Support_Options/Support_Percent
See the image in the examples section of the above linked page for a visual representation of how it works.
...Ok now it is clear, thank you for the information