Geeethech A10T
-
How to set up the extruder correctly when turning on 2, only one heats up and 2 goes into error
Just as a result, the thread is loaded and there is no heating on it, I have already tried everything, I think there is someone who has faced such a problem
-
Hello
This is a bug from the software.
You must deactivate the "SHARE TEMPERATURE'"
You can have 1, or 2 or 3 extruders.
After, at the top of the soft, you can see 2 or 3 extruders , where you must set the T° to ZERO °C , for extruder 2 and extruder 3For me, i have the Geeetech A20M... and it was so long to find this "stupid idea"
Now it works ...
I could add my Geeetech A20M , using the "prusa i3 preset", and add 2 extruders.
I use my Geeetech with ESP3D to print by Wifi for small pieces. and by Sdcard for long time prints.