Software Print leveling not stopping at bed height during calibration



  • So, I am trying to run the mattercontrol software bed leveling and it's now completely ignoring the probe sensor and not stopping while going down on Z axis. It's worked before without issue. No settings have been changed. Help please! I can see the sensor probe going down, but it ignores and keeps pushing down on bed. Thanks in advance!


  • Moderator

    Sounds like we're going to have to do some troubleshooting. Can you send a message to support@matterhackers.com?


Log in to reply
 

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.