Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you may not be able to execute some actions.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

levelling

andy4751 last edited by

hi can anyone tell me where the setting z can be negative is in matter control version 2 i can find it in the older version but not version 2
Reply Quote 0
1 Reply Last reply
mpirringer last edited by @andy4751

@andy4751 I think its under printer on the general tab all the way at the bottom under nozzle offset
Reply Quote 0
1 Reply Last reply
andy4751 last edited by

thanks for the reply but no its not there
Reply Quote 0
1 Reply Last reply
mpirringer last edited by @andy4751

@andy4751
Reply Quote 0
1 Reply Last reply

4
Posts

3932
Views

Log in to reply

1 / 1