Hot end temperature controls missing-on-MatterControl 2-19
-
Re: Hot end temperature controls @ 0 on-mattercontrol-2-19-with-i3 2020 clone
It connects but there is no control? Using a MKS Gen 2
image url)
-
@zizixa go into the terminal and see if you get any response by entering M105 or M155 Look up the syntax for the proper parameters for you I would guess for your hotend to be T0 so it would then be M105 T0 If you don;t get a response you might not be connected properly or your firmware is configured to not report
-
Thank you for the reply,
this is the printer not communicating or connecting correctly with the MC software?
on connect manny times it will not see the port and i will have to switch on and of and unplug many times to no avail.
but i have a clue... that may help ?
if i remove the printer (after it had done many prints)from MC and add new printer it then connects correctly and shows HE and bed temp .
-
@zizixa When I was using MC I had to create a new printer a couple of times for a variety of reasons. Sometimes all it took was an upgrade
