Error:MINTEMP triggered

Eko3D

I have a problem with this message: Error: MINTEMP triggered.
I noticed that for an unknown reason the temperature of the heads suddenly drops. At different times of the same print.
ok
N22935 G1 X35.35 Y97.33 E1204.088*84

ok
N22936 M105*43

ok T:205.12 /210.00 B:89.18 /88.00 @:127 B@:0
N22937 G1 X33.48 Y95.32 E1204.184*84

ok
N22938 G1 X31.78 Y93.38 E1204.274*90

Error:MINTEMP triggered, system stopped! Heater_ID: 0
Error:Printer halted. kill() called!
N22939 M105*36

N22940 M105*42

N22941 M105*43

N22942 M105*40

N22943 M105*41

N22944 M105*46

N22945 M105*47

N22946 M105*44
Marlin 1.1.9 Arduino 1.8.8

PLIS HELP!:)

Eko3D

This post is deleted!

ErikEscudero

It sounds like your thermistor may be going out / bad.

Using a multimeter, set it to 100K Ohms and probe the thermistor at room temp.
The thermistor should read ~100K +/-20 ish.

If it is extremely high or low, you may need to replace the thermistor itself.

Eko3D

You're right, I just mentioned it and it's good I came across this too, thank you very much