MatterControl 2.19.6 now reads Gcode
-
Upgraded again to check the hotfix and at least for my first gcode file created with SLIC3R it prints now
Thank you
-
How did you get it to work? I just downloaded the 2.19.6 version today and I still have this issue. I use ideamaker to slice my models because I'm so used to it, but when I enter into matter control it still says the bed is empty even though it's on the screen.
-
I upgraded to 2.19.6.10317 Go to about mattercontrol and see if it is that version if not upgrade to it
-
I just downloaded it again and its version 2.19.6.10321, I hate to think they didn't keep the hotfix on newer updates. I tried looking for your specific version but can't find it. the definitely need a "previous versions" tab on their software.
-
on my other computer I got 10328 and that one works too. See if you can upgrade to that
