Pulse C-232 taking "breaks"/pausing
mpirringer last edited by
If you print complex things like helical gears on print jobs that take 12 to 24 hours after a number of prints you will get pausing in the print for a few seconds to a minute. If you get into the terminal you will see a message "processing busy". To avoid that
Go out of MC after evry couple of prints
Turn the printer off then on
Go back into MC.
I have verified its not the gcode as it prints fine after turning on/off (same gcode file) Now the files are quite complex 300,000 to 800,000 facets etc using 250 to 400g of filament. So if you have that issue for now just every 2 or 3 prints turn the printer off and exict mc and then turn it on again