2 questions about automatic bed leveling
-
Hello!
I'm loving Mattercontrol because of the software automatic leveling feature
I have two questions regarding this feature:
If I open a gcode file in matter control with the feature turned on, will it aply the bed levelling to th gcode ifI export it and leave all the settings intact?
I want to print a test calibration for temperature. So I need to enter the gcode to set a new value each X number of layers.
When the machine is workingI see that Z vaues change constantly due to autolevel... will that be a problem when modifying the gcode? or how should I do that?
Thank you!!
-
@alc112 said:
If I open a gcode file in matter control with the feature turned on, will it aply the bed levelling to th gcode ifI export it and leave all the settings intact?
Yes.
@alc112 said:
When the machine is workingI see that Z vaues change constantly due to autolevel... will that be a problem when modifying the gcode? or how should I do that?
No, modifying the G-Code will not be a problem. Think of the auto-leveling process as a filter that the G-Code runs through on its way to the printer.
