Drive 542T Program with Nema23 Motor
-
Good evening everyone,
I would like to ask for advice on how to program my Drive 542T with software output using stepper motorsNema23 stepper motor([https://www.oyostepper.com/goods-1198-Nema-23-Stepper-Motor-24Nm-33979ozin-4A-57x57x82mm-4-Wires-8mm-Shaft.html](link url))4.2 A, 3Nm, angle 1.8 degrees, I set the first three switches (SW1-SW2-SW3) to OFF, SW4 to ON, SW5 and 6 to OFF, SW7 and SW8 to ON, corresponding to 800 pulses.
However, with this setup I noticed that the motor runs at a low speed, and then after restarting it takes a while to reach the expected speed.
Although this may be insignificant to you, can you help me understand how to set up the drive according to the type of motor.
Thank you