printing calibration cube fails with each layer offset to different position
markfarnell last edited by unlimitedbacon
I am running mattercontrol 1.4 on Ubuntu 16.04. I am using a prusa mendal i3:
which has a dual extruder, but I set the number of extruder to 1 to disable dual extrusion, and solely use extruder 1. I also turned on the raft feature.
When I print the calibration cube, each layer is arbitrarily offset in both X and Y directions by about 20mm. So are there anything wrong with the settings on mattercontrol, or is it the firmware problem?
I did not load any firmware onto the motherboard of the printer. I am just using the motherboard out of the box from the full kit
unlimitedbacon last edited by
Layer shifting can be caused by a lot of things. Did you have a look at this thread? Could you provide some pictures?