E3D 24V kit built; Lulzbot TAZ 5
-
I just built an E3D 24V hot end. I'm attempting to hot tighten the nozzle. I set the temperature to 285 (or 260), and wait. Somewhere just over 150, my TAZ 5 comes back with:
"E1 Heating Failed
Printer Halted
Please Reset"Marlin version 1.1.9 v.34
So, any recommendations? I didn't have this much trouble the first time I installed an E3D 24V kit onto my TAZ 5.
-
In answer to my own question...
While attempting to hot tighten, I had the parts laid out and plugged in, but not assembled inside the print head when I got the error.
In desperation, I assembled the print head on the printer, and then started up printer. Found Home, raised the print head 60mm and over on the X axis until I could fit the wrench (about 150mm or so). I raised the temperature and no error thus far.
Lesson learned, hot tighten on the TAZ 5 fully assembled.