Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you may not be able to execute some actions.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Using a Titan Hotend in direct drive mode with an Ender 3 v2 !!!! Is it possible??

S

SubseaUK last edited by

Hi, I am looking towards fitting a Titan Hotend for PETG & ABS on an Ender 3 v2. Does anyone know if this has been done or even if it is possible without too much alterations? I am a relative newb when it comes to modding.
Any help appreciated.
Thanks
Kev
Reply Quote 0
1 Reply Last reply

1
Posts

3084
Views

Log in to reply

1 / 1