WorkHorse and Pro Z offset reapeatability

  • We recently purchased Lulzbot Workhorse and Pro printers which do not repeat with their respective Z offset from print to print, my belief is that the automatic bed leveling sequence is hitting way to hard on the initial hit during which it is pressing the bed down an estimated .07" to .1" which does not allow the bed to reset correctly for the slow touch. I am wondering if there is away for me to change this process without reprogramming the firmware completely. We do not have a lot of detailed experience with edit the firmware. We did not have this problem with our TAZ 6's. This the only major item that is plaguing us, as long as we tune in every time the results have been great.

Log in to reply

Looks like your connection to MatterHackers Community was lost, please wait while we try to reconnect.