Tronxy X1, Matter Control cannot connect to printer
-
Hi Everyone,
I bought a Tronxy X1 and I can't seem to get Matter Control to connect to it. It uses a Melzi board with repetier firmware installed. Has anyone got Matter Control to connect to their Tronxy? I selected other -> other on the drop down menu for 3d printers.
-
Have you checked the Baud Rate? It may need to connect at 115200 but the default is 250000.
That is the first place I would look.
If that doesn't work you should check and see if you can connect with just a terminal program.
