Kossel Mini prints off the bed!
-
I have no idea what I have done! I have been printing for months using Mattercontrol with excellent results. Now my Kossel Mini - bed levels, warms up and then shoots off the bed between the Y and Z towers. An emergency reset stops it being silly. A test print with Cura is fine. I haven't the foggiest how to stop it doing this. Any ideas?
-
Solved it!
I needed to set :
Print Area, Print Centre - 0,0 It was set - 100 100
General, Centre Print - OFF It was set - ON
Now prints in the centre of the bed.