Bed Levelling adjustment, no 0.1mm small steps.
-
When via the software I go to calibrate the auto bed levelling the Z axis moves down in large steps, there appears to be no fine 0.1mm adjustment. Have I missed something.
-
Each point in the MatterControl Software Print Leveling configuration wizard has three levels of adjustment which run in succession: rough, medium, and fine. 1mm is rough; 0.1mm is medium, and 0.01mm is fine. Click 'Next' once you finish rough, then medium, then 'Next' again, then fine. This is done for each point.
http://wiki.mattercontrol.com/OPTIONS/Software_Print_Leveling#Wizard
-
Thank's Ryan, I completely missed that....