This is related to getting the z offset in the firmware for the pulse and this is now under review to add the z offset I was told. still in testing.

ok, lower temp to 190, slow print speed some for test...
try a over hang bridge test ...https://www.thingiverse.com/thing:2972495
you can find me on discord if you need help Zoromer #0532

Good info. i called Matter Hackers help desk and reviewed with them about using Cura or other slicers I was told that they are working on added wifi to the 32bit board right now by the working on updates to the firmware and he is working on making a update to allow z offset update to the firmware to allow us to use other silicers. but then it order rises the autobed leveling... he was looking at a answer for this.

They sell the Ultimaker so it is madness you cant run Cura native. We just need to allow for doing a Z offset in the firmware if you ask me.

Cura profile or Prusa slicer.

It looks like their is no way in the firmware to setup the bedleveling or to use the auto bed leveling without having to releveling each time. So just making a standard profile for one of the other slicers is not cut and dry.

in order to get what need to make this work i plane to post my findings and changes here. If need be I will even replace my printer if i have to.

please post here if you want to have the frimware updated by matter hackers to allow us the easy and best options to use other slicers.Please post here your request for a update. I will link here the full process as needed after the frimware is updated and get Ultimaker to add a default profile to Cura as well.

I will be using a Pulse XE S-234

Please note i do not work for any of the groups listed above and this is on my own time. If you need help I can be reached on discord at Zoromer#0532 https://discordapp.com/ to install if needed.

My bed just stop working well on my pulse XE S-234 it was working fine then just stopped... my unit has
the 32bit board...