@michael-petitclerc Thank you. It's set correctly to D-211. I haven't added Viki yet but will contact support when I do.
Posts made by Ukytreats
-
RE: Pulse D-211 Matter Control Firmware update
-
RE: Pulse D-211 with BL-touch, should it run the Auto Bed Leveling before each print
@michael-petitclerc thank you for the suggestion. I give the increased bed temp a try.
-
RE: Pulse D-211 Matter Control Firmware update
@michael-petitclerc How do I check if there is a mismatch? I also ordered a panel but haven't installed it yet. Will I need to update the firmware when I do install the panel?
-
RE: Pulse D-211 with BL-touch, should it run the Auto Bed Leveling before each print
@mpirringer Thank you again, I use PLA, PETG and TPU. But the two STL files I was trying to print were in PLA. The bed is a PEI Sheet. I tried a glue stick slushy but It still didn't stick at the nose of the elephant. Brim might be worth a try. I think I'm running N210 B60. I'll also try to increase these to see if that helps.
-
RE: Pulse D-211 with BL-touch, should it run the Auto Bed Leveling before each print
Thanks for the reply. That works for me. I've been trying to print delicate prints like this and this
https://www.thingiverse.com/thing:3576952
and
https://www.thingiverse.com/thing:257911
most of the prints are fine but in both cases after the fist layer the tail on the cat and the trunk on the elephant come off the bed. -
Pulse D-211 with BL-touch, should it run the Auto Bed Leveling before each print
Hi I have the D-211 with a BL-touch. I can run the Bed Leveling from the config menu but was wondering if it should run automatically before each print and if so how do I set that up?
Thanks
-
Pulse D-211 Matter Control Firmware update
Matter Control reports a firmware update for my Pulse D-211 but it never completes the update. It backup the exists firmware then starts the update but it never completes.