Posts made by Trizz1964

also I just reread your first post my mistake on the temp I was thinking pla-pro 200-220 how have you made out with the removal of the Bowden tube?

make sure the extruder is at temp 205-210 go into the control in matter control upper right corner turn on extruder for preheat. on the Bowden tube going into the extruder pull the little clip out its so small and black right on-top of the extruder under the fitting for the tube, then push the fitting down and pull out the Bowden tube, to do the extruder calibration at 100mm make sure to do about 4 lengths then average them out, cut the filament right at the end of the Bowden tube flush to the end then extrude the 100mm all calculations have to be done in the eeprom setting upper right corner E stands for extruder should be like 470 mine was after measuring the filament 472 so I inputted the new measurement of 468 if you need any info I'll be more than happy to try and assist you, as they say one hand washes the other..

add zlift 0.4 start at and add some more retraction like 10mm also on the first layer try starting first layer at 105% also do a extruder calibration mine was off by .3 over extruding I have a pulse xe I purchased about 2 weeks ago same dam problem
here's a link for you https://www.matterhackers.com/articles/3d-printer-troubleshooting-guide

how would I edit the g-code to do this? its easy in simp3d or cora but trying to find a place to add or adjust temps in matter control is weird. This is all new to me, thank you for any help.

is there a way to do a temp tower test in matter control software trying to figure out how to add
temps at a 5mm increment

Depend on the filament your trying to dry as per temp wise, usually about 60 to 80c for a few hours then either put it in a air tight container with some desiccant or a heavy Ziploc bag with desiccant will do the job for storing.

tried to export the file and import to Simplify3d but not showing up.

Hay, Guys.
Is there a Profile for my Pulse EX that I can import to Simplify3D as per the settings I would love it if there was a way to copy over the file from matter control and import it to Simplify3D that way I would have all the filaments and so-on and not have to pull my hair out trying to build a new profile...
thanks guys..
with kind regards Michael..

I would also do a reboot of the computer to take anything out of resident memory, and then do a disk defrag on a hard disk or a optimize on a ssd then do the install...

if you can't find one to your liking from matter hackers, this is the only place I would buy from, next is going to be G-create gmax 1.5 plus 3d if your going large 16x16x21..