hi long time user of mattercontrol and i am having issues on the bottom of each print. so i like to use Elmer glue very thin for my prints when using pla. and after the printer does its leveling check on the very last level check spot it then does not lift up again rather it simply drags the extruder across the glass to the center and begins to print. this leaves a line in the bottom of each and every print i make now. i am not sure if it did that before the new firmware releases or not but it needs to be addressed. is there a line of code i can change? if so what line and to say what? still using robo3dr plus version printer here. in case that info is needed to help me.
Posts made by tommy2toes
seeing a line on the bottom of each print. help!
no support ground up only, heat bed bad plug or pad?
i use support alot only i don't want to support everywhere only the ground to the first point not everywhere. am i missing something i can no longer find this option i had to go back and load the older firmware for now until this is fixed. please help if you can. now 2nd my heat bed is out i need a replacement heat pad for the robo 3dr plus. and the plug that connects the pad to the printer needs replaced they all have burned up on every printer i have head about of this version. faulty plug so do you have a replacement for this?