I followed the guide to the letter. When I used the software print leveling in mattercontrol it suggested raising the value in eeprom of XYZ, respectivley, max length. All three are set to 382mm. This has allowed me to get prints started. However now the ezstruder isnt feeding filament, IM researching how to adjust the hobbed gear, it goes through the calibration process but stops feeding filament during test prints after the first couple of layers...
Posts made by terratian
RE: Max V2 1st print failure
Max V2 1st print failure
I have just finsihed building my v2. I followed all steps in the manual. When attempting to print it appears as though the printer is trying to print off of the bed. When I looked at the eeprom from mattercontrol XYZ home pos are all set to 0(Shouldnt these be set to the center of the heated build platform?). Also Delta Radius ABC are set to 0 ( shouldnt they be a division of the radius?). Any help would be greatly appreciated.