I hooked a new LCD screen to my R1 + last night with a good firmware update. I unhooked the USB, and was able to heat extruder and bed and homed the extruder. It did not show my SD card (16 gb) so I attempted to reload my file to my SD. I then found the LCD screen was frozen now and would not respond to dial changes. Not knowing what else to do I turned off my machine, and restarted only to get a plain blue screen. I uploaded the firmware again and still nothing. Any suggestions?
Posts made by Sybeck1
Newly connected RepRap LCD screen worked a few minutes then stopped
Support is a full block not usual seperate lines
First post. Been using Mattercontrol on my Robo R1 plus for a couple of years. Now for some reason I got a full block of support material that broke away fron this overhang and not the usual ribbed support I normally had. It's this a setting in MC? I did just install a newer version. Thanks