If you could provide some instructions, I would be happy to give them a try. In the mean time, I will believe support when they tell me the computer has to be connected to the printer on initial setup.
sperman
@sperman
Posts made by sperman
-
RE: Can't Export G-Code
-
RE: Can't Export G-Code
Support has confirmed that the computer has to connect to the printer on initial setup. (Unlike every other slicer I've used.)
-
RE: Can't Export G-Code
I have added the printer in the software. After the first step it says "plug in the USB cable." At that point my only option is to cancel the wizard. The printer was created, but it still won't let me export.
-
Can't Export G-Code
I have recently purchased a pulse printer, and it is working great. I have installed the matter control slicer on my work computer, and would like to slice the models and export the G-Code to an SD card. This computer is in a different building than the printer. I don't want it to control the printer, just to slice the models. When I go to export the G-Code I get a message saying:
"Disabled: Setup Needs to be Run."
Is it possible to export G-Code without physically connecting to the printer? None of the other slicers I've used have this requirement, so I feel like I must be missing something simple.