Thanks for your response!
I was watching their video tutorials and saw that they left the magnetic build plate off when doing the nozzle distance check yet I saw or read somewhere else to leave it on...confusing.
That would make sense in regards to the tubes. I guess the newer machines get shipped with the latest firmware and have the correct bowden tubes for that version.
Well back to playing with the printer!
Hello, I just got this printer over the weekend and not being too successful with printing..
Two Questions:
1. When setting the nozzle distance, do you leave the build plate on or off.
2. After updating the Firmware to 2.11, when I load the filament it stops about halfway in tube one or two. Before, it would take it all the way to the extruder where I would then manually move the filament through the nozzle. Did something change or is there a setting somewhere I need to adjust?