@r0natmatter Regardless of the belt tension, it always seems to slide up against the idler and the 'back and to' motion has been wearing it away. I obviously replaced this and did my best to re-fit the idler but the same problem is still persisting with the belt riding up against the idler. I have been searching for a toothed version as I think this will keep it more aligned.
In all honesty, PrusaControl is all I have been using and this last attempt I just decided to see what the Slic3r was about. Same result in both instances.
I have ran calibration tests and all have been 'green lighted'.
I guess I will just play around with it in order to figure out a solution as people like rob232 just post useless comments that serve no purpose. Let's hope he doesn't get stuck on anything in life ehh...