Just got my Pulse D-111 printer, went through the calibration steps as instructed, worried that I set the nozzle too low, re-did Z Calibration and noticed nozzle was testing halfway to the left side of the plate (looking at printer from the front) from the center point. On first print, first layer heads straight off the end of the plate and there is some grinding in the belt motor trying to come back the opposite direction. The plate movement (Y Axis) seems fine. I noticed that the Z Screws were slightly off so I manually rotated one until it was the same height as the other. Re started the test print and the exact same thing happened.
This is my first 3D Printer, first time doing anything like this, so looking for any help I can get. I am a fast learner but do not know where to start. I can provide pictures/videos.