CR10S5 .8mm nozzle [0_1610768626199_PrusaSlicer_config_bundleforducatidie.ini](Uploading 100%)
The printer auto homes just fine. Once up to temp, it does the nozzle wipe just fine, and when it goes back to home before the print, it just slams into the bed. So this problem has been getting worse and worse. The first time it happened, I figured it was just a fluke. Then I figured the z limit switch wasnt bent enough and just wasn't engaging. I double checked level and it was fine, reset the home offset, and it worked perfectly, then the next print did the same thing. I'm new to 3d printing, and this is driving me crazy. Any advice would be helpful! Thank you [0_1610768733866_Top Die.gcode](Uploading 96%) [0_1610768631709_Top Die.stl](Uploading 100%)