Hello, new Pulse XE owner here and I have a few questions I could use help with. The Pulse XE I have has the upgraded motherboard, steppers and LCD screen. I have tried several prints via my PC and by the SD card to see if it made a difference or not. I have done the normal troubleshooting stuff so far, like changing the temps up n down 5 degrees, moved the print around on the bed, checked to make sure no screws are loose or to see if anything doesn't look right.
Adhesion has been great, no issues there at all, though I have only printed with MH Ryno and some Polymaker PLA just to test with so far as I want to get it dialed in first. I have done the calibration setup several times and honestly, the first layer looks pretty solid so I'm wondering what I should be looking at next.
Phil printed with Ryno @ 240/55 w/ glue from the PC via Print Dry: 
Every benchy has the same issues no matter the size or temp (240/245) printed with Ryno: 
Generic Square I printed to test first layer with Ryno:

Test cube in PLA, this is the best one I got so far, but there seems to be some shifting going on to the right of the cylinder: 
Possibly something with the X or Y Axis? The calibration has been run 3-4 times now and always comes out good, plus the printer IS level on my work bench. These have all been printed via Mattercontrol, though I do plan on trying Slicer just to see if I get the same results with a print.
Well, any help would be appreciated.
Thanks.!