So having separate temps for the first layer doesn't make any difference in prints? I was just curious about using it because others I know use Simplify3d and it allows them to select different temps for different layers. Most use a higher temp for the firs t3 layers then drop it down and start the fan. I assumed there was a good reason for it.
naviathan
@naviathan
0
Reputation
2
Posts
632
Profile views
0
Followers
0
Following
Posts made by naviathan
-
RE: Getting Started information missing...
-
Getting Started information missing...
On the getting started page here: https://www.matterhackers.com/articles/mattercontr...
Under section 9 it lists the following:
- Filament > Temperature: Separated into first layer/other layers, this setting will dependant on your material. If you find that your filament has trouble sticking to the bed, try setting the temperature a few degrees hotter for the first layer than the rest of the layers.
Emphasis added for the settings I can't find. There is nothing in the Filament > Temperature section for first layer. Was this removed for some reason and never corrected in the getting started guide? If it was removed, why? I was hoping to use the first layer settings.