I have a couple of Nexus 10 tablets laying around collecting dust. Would it be possible to get the T10 software (or ROM) to use one of these tablets for the same purpose?
Posts made by mrsatov
Can we have the software to run on our own Android tablet?
Manual bed leveling wizard says Warning - Moving Too Low
I have used this tool many times. I HAVE had issues with it where it would not move low enough to touch the bed, but I could fix by setting both sides of the Z axis evenly and/or adjusting the Z stop. Suddenly now when I start the wizard and get to the first adjustment, when I click the Z- it immediatly says the position is too low and can't move. Despite the fact that I have it set to 5mm above stop (usually 10, 10 does same), and it does lift up what looks like ~5mm above the bed when going to the first of the 7 level points. I tried the usual adjustments but nothing will stop it from doing this, or allow me to move it even one step. Extremely frustrating!
RE: Value of the Z Offset on Matter Control for a Glass plate over my Bed
This forum is apparently not very well monitored... 2 months and no response. That's sad.
I have a glass bed on my Zonestar Prusa i3 clone. I just added it on top of the existing aluminum bed. I changed the z axis end stop so that it homed just below the surface. Then used the manual leveling (7 point) wizard to set the height. Works well. I'm pretty new to 3D printing and I'm sure there's a better way, something more "scientific", but can't argue with success. LOL
bed leveling wizard not centered
I'm using the 7 point leveling "wizard" and first few go fine, but when get to the first point left on bed it is about 8mm off the bed to the left. I might say that the entire thing is 8mm off. What is the best way to configure the printer or software to put center on center?