When printing now it loads the bed temp - then after it reaches the bed temp it loads the extruder temp and then heats up the extruder. Before both were done simultaneously. Did something change, or is there a setting to cause this to happen that I changed somehow?
Posts made by mobilemax
Extruder temp after bed temp
MatterControl after Arduino IDE wont connect printer
Matter Control won't connect to the Ultimaker 2 extended + after running the Arduino IDE to program a Mega 2650 board. It shows Com3 as existing but won't connect. Any ideas?
RE: USB message
the T10 still is pot luck whether it will make it through a print or not. Is anyone else able to repeatedly complete multi hour prints without the T10 errors? It will just stop in the middle of a print just like it thinks it is done. It is intermittent. My guess is that it has something to do with the USB. One time it was sitting at a screen wanting to install a software update. Again I have wasted a lot of filament (see my post on the 3mm PLA pro filaments).