@michael-petitclerc I was using painters tape and glue but I gave up on it and switched back to sugar water. I found it was sticking well to the tape but the tape was bubbling after being on the bed for so long. I have gone back to sugar water the only big problem with it is sometimes you have to soak the print and the bed for a while to get it off. That and it draws ants in the summer :}
Posts made by LBivens
RE: PETG warping on very large prints
PETG warping on very large prints
I'm trying to print a very large object in petg. My problem is after the 1st 15 or so hours it's trying to warp off the bed. (tape and glue stick) Why would the warping start so long into the print? The object was over 1 inch tall before the warping started at all. This is one of three parts I'm printing that get bolted together so If it doesn't detach itself from the bed I should be able to Bondo it together but I don't understand what's causing it. the bottom inch shouldn't be changing temp for it to warp. I would have expected layer separation more than the bottom warping.