I am very new to 3d design and 3d printing, but I have been able to figure out quite a bit by just playing with MatterControl 2.0. There is one Key piece that I can not figure out, how can I position a hole in an exact location? I understand how to create the cylinder and then remove it, but I can't seem to figure out how to give it an accurate position. to make this as simple as possible, I have a 3mm thick rectangular base that is 60mm X 80mm, how can I place my hole center exactly 3mm from a corner on that part? Also, is there is a good location where I can find design tutorials? I've skimmed through Youtube but haven't found anything great yet. Thanks
Posts made by KD7VEA
how can I calculate where to place items in a design.