@AReed030188 as unlimitedbacon said 195c sounds awful low but also the bed should be around 60 Several things can cause jams so more setup info is needed IE have made any mods to your ultimaker? going on that its all stock its not much different from my custom built Bowden feed nozzle diameter so lets touch on the possible causes of a filament jam on this setup
in testing i got these very frequently here some steps took to solve the issue (since about 20ish prints no more jams)
1. Is the cooling fan for the heat break activating from time the hot end starts to heat up or from looks of ultimaker design large heatsink? (my case i altered the marlin firmware to turn it on when ever the hot end is 50c or above.)
2. is your first layer being squashed against the bed?
3. Temp and first layer height pulled right from colorfab's sight on XT and ultimaker2
ULTIMAKER 2 – SPEED AND TEMPERATURE SETTINGS
4. lastly is the bowden extruder set to tight and digging into the filament? (cause filament to jam in the hot end) if it has been in past it will scour your ptfe tube and cause jamming
hope one of these helps your issue and happy printing