so i tried pla no issue its only a issue with petg like if its balling up on the end of the nozzle

So far. I mostly run PETG and Nylon in my office. I tried loosening the fans a bit this morning and things are looking better i will try to print new shims today and see if it helps

I just installed a new 3D Solex Raise3D Pro2 Everlast Ruby Nozzle - 0.40mm
and i cant seem to get the bridging to print cleanly at all with petg. I haven't tried other types yet

Does any one have any ideas on that is wrong i havent had this issues until now