Is there a way to change the position of the wipe tower? I see controls to change the size but no way to change where it prints the tower. I have had several prints where it puts the tower too far to the left for the second extruder to actually print. Mattercontrol apparently doesn't know where the limit for the 2nd extruder actually is so it just moves as far as it can and then squirts out a big mess.
Posts made by jspreiss
Wipe tower position
Mattercontrol shutting off 2nd hotend
Hey, folks...looking for some help. I have a Pulse DXE dual extruder model that I recently purchased. It's been working fine up until last night. For no apparent reason, every time I try to print something using support material in the second extruder, Mattercontrol commands the temperature of Hotend #2 to zero. Hotend #1 and the bed will heat to the temps in the slicer settings but hotend 2 does not get commanded on. If I manually command it on, as soon as the print commences Mattercontrol commands it back off. I don't believe I changed anything that would cause this behavior. Any ideas as to what might be causing this?